That is because this kind of gas contains components that dissolve and drag away even the chlorophyll, so it is not clear even with fresh weed. With gases like Dimethyl ether it is very difficult, not to say impossible to get a shatter that is not dark. This way cold does not allow the solvent to drag away waxes and Shatter concentrate becomes very clear. Weed should be put in the freezer freshly cut and an extraction tube with chamber is used to introduce dry ice. To achieve a clear or as transparent as possible shatter it is necessary to work with fresh material, and as cold as possible during extraction process. In this case it could be called Shatter Wax, as it usually has a dark amber colour. When you extract dried resin from cannabis with a solvent it drags waxes, lipids, chlorophyll and other plant components. How to make clear BHO Shatter or transparent? You will see that a thin BHO layer remains with a hard and not very sticky texture unless we apply heat to it. We leave it at a constant temperature for a few more hours and it may be considered done. Until a moment comes when they are very small and when they explode they break up into small rigid lumps, at which point the extraction is almost clean. Then the bubbles will be smaller and smaller and we will notice that when we blow them they are harder and less sticky. Large gas bubbles will come out at first, which if we pop them we help it get out sooner. Then it is placed on a heating plate at a temperature between 104 and 111º F. BHO is extracted on a pyrex plate to which we have to put baking paper or a silicone tablecloth, trying to make a homogeneous layer. With the help of a hot plate, time and patience you can also achieve the Shatter finish. At the beginning the extraction is swollen with the vacuum pressure, but as time goes by it will make less and less bubbles, until at some point, where there was air and bubbles, holes are formed, and the concentrate acquires a hard texture that is no longer sticky. (45º C.) and a vacuum pump of at least 1 bar of pressure, but the more powerful the better. In this post you can learn how to make BHO in an easy way, once extracted the ideal is to eliminate the gas with a temperature that does not reach 113º F. The technique to get the texture of BHO shatter has more to do with the purging than the way of extraction. This way we get the Shatter texture without doing anything else, in some cases it takes a day and in others it may take up to a week.īut not everyone can afford to invest thousands of dollars in equipment for cannabis extraction, so we’re going to explain how to make Shatter in different ways. We take out BHO and put it in the vacuum oven on a pyrex tray or similar, turn up the temperature to 98.6º F. We put the weed in the corresponding chamber, close it, turn on the gas, wait a little bit and then recover the gas. The best way to make BHO Shatter is with a closed circuit machine and a vacuum oven connected to a pump, for safety, speed and for its ability to restore the gas.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |